=  NOW 30 WPM  =  TEXT IS FROM JANUARY 2023  QST  PAGE 58  =

PANEL.  THE SCREW ON THE TOP IS 3/8 INCH FROM THE CORNER, WHILE THE SCREW
ON THE SIDE IS 1/2 INCH FROM THE CORNER.  THIS WILL ENSURE JUST ENOUGH ROOM
FOR THE OPPOSING NUTS.  NUMBER ALL OF THE PANELS AND ANGLES, THEN LABEL
THEIR POSITIONS IN REGARD TO ONE ANOTHER.  THIS WILL PREVENT A MIX UP OF
THE HARDWARE DURING TRIAL ASSEMBLIES.  DEPENDING ON YOUR ENCLOSURES SIZE,
DECIDE ON THE SPACING AND PLACEMENT OF THE MACHINE SCREWS CONNECTING THE
ANGLES AND PANELS.  AFTER MEASURING FOR SCREW PLACEMENT, DRILL THE FIRST
HOLE 1/2 INCH IN FROM THE END OF THE ALUMINUM ANGLE WITH A 3/32 INCH DRILL
BIT.  DRILL THE HOLE THROUGH THE ALUMINUM ANGLE AND PANEL TOGETHER.  THEN,
DRILL THE HOLE WITH A 9/64 INCH DRILL BIT TO TAKE A 6 32 X 1/4 INCH MACHINE
SCREW.  DEBURR IF NECESSARY.  LIGHTLY TIGHTEN THE ALUMINUM ANGLE AND PANEL
TOGETHER WITH THE SCREW AND A LOCKNUT.  THE SECOND HOLE WILL BE MADE AT THE
OPPOSITE END OF THE ALUMINUM ANGLE.  FOLLOW THE PROCEDURE ABOVE, AND ENSURE
THE PANEL MESHES PERFECTLY WITH THE ALUMINUM ANGLE.  TIGHTEN THE SCREWS AND
CONTINUE WITH THE REMAINING SCREW PLACEMENTS.  ASSEMBLE THE UNIT TO ENSURE
ALL OF THE PARTS FIT CORRECTLY, WHILE REFERRING TO THE POSITION NOTES YOU
=  END OF 30 WPM TEXT  =  QST DE W1AW  <