Tower Grounding
Displaying 1-1 of 1
| Mar 7th 2021, 19:45 | |
makitaman60Total Topics: 0 Total Posts: 0 |
Tower height will be 40' to 50'. I would like to run a #4 copper up each leg to point just above the thrust bearing and form a small circle of #4 to tie the three runs coming off the legs. Trying to shield the rotator and thrusts bearing from any high currents from a strike by having a better more negative or positive route. I've seen this done and it works well as long the ground is equal at the top and bottom. If I can get 25 ohms or better measured at any point in the grounding system should be fine. No welded thrusts bearing a no welded rotator gears. I want that strike in the ground ASAP. Any ideas will be greatly appreciated. Thanks kk4byd Tom |
Displaying 1-1 of 1
